Ninco, now being distributed exclusively by Professor Motor in the U.S., is reintroducing a series of five somewhat generic Formula 1 cars to its lineup, a good product for clubs or groups that enjoy racing identical cars.
These racers resemble the former SCX F1 cars in that the front suspension looks real, with A-arms and wheels that are steerable, being controlled by the slot’s movement. The body resembles a Team Jordan F1 car from the late 1990s to early 2000s and in fact is labeled Jordan on the chassis.
This racer is sturdy and likely the body will hold up well in heavy use. The nose wing is thick and well attached to the body shell as is the rear wing, which is molded into the bodywork, so less likely to snap off when the car de-slots. Its mirrors are the most likely body part to be lost over time.
That said, as with the former SCX models with steerable front wheels and a more detailed suspension, I suspect the thin suspension parts will snap after several heavy hits into other cars or during a serious de-slot. The good news is the cars will run even with damaged front suspensions, they just won’t look as realistic while on track.
Ninco uses its normally peppy NC-14 Speeder motor that generates 20,600 rpm. Straight line speed should be good, but on my test track the car was more than a full second slower than a similar Scalextric open-wheel car, with silicone tires. Silicones usually will cut a half-second off a lap time.
The standard tires here are a very hard rubber and grip is minimal. They also are quite stiff, so hard to remove from the wheel, but you’ll want to purchase proper silicones to give the car more grip. That helps in turns, but also in putting power to the track in a straight line.
The magnet Ninco uses is small too and sits in front of the inline motor instead of behind it, as in many other slot car chassis. That placement doesn’t help give it good rear tire grip or balance, so likely with slicks the Ninco will still be a hair slower that competitors. Again, if your buddies are all racing the other Ninco F1 cars, that won’t matter.
For gearheads, literally, the Ninco F1 has a 2.48mm axle and 9-tooth pinion and 24-tooth crown gear. The car weighs 73 grams and feels quite solid.
The test car was red with white and black trim on the wings and car’s sides and engine cowling. This is car No. 3, while the other cars in this series are No. 5 in black with slight yellow trim, No. 2 in blue and white, No. 15 in yellow and black, and an all-white model you can decorate yourself.
Experienced slot car racers will recognize this as a somewhat simplified F1 car, but a good looking car for a newcomer. But you’ll need silicone tires and likely an additional magnet to keep it firmly planted on the track and able to use its power.
Product: Formula 1 (red)
Maker: Ninco (now available from Professor Motor and hobby stores)
Stock No.: 150697
MSRP: $64.99 (you can usually find this for sale in the $40-45 range)